9. MAJOR UNIT REPLACEMENT EO18-33027
9.6 RIBBON MOTOR SENSORS (TAKE-UP, FEED)
9-14
5) Replace the ribbon motor sensor (feed) with a new one, then reassemble in the reverse order
of removal. At this time, take care of the following points.
• Attach the ribbon motor sensor (feed) to the ribbon sensor plate (feed) in the correct
direction.
• Fit the positioning tabs of the ribbon sensor plate (feed) into the positioning holes of the
ribbon motor block.
Positioning Tab
Ribbon Sensor Plate (Feed)
Ribbon Motor Mounting Plate
To Next Page
Loading...
