TR-Electronic CDV582 - Page 153

Printed in the Federal Republic of Germany  TR-Electronic GmbH 2019, All Rights Reserved
11/21/2019 TR - ECE - BA - GB - 0139 - 02 Page 153 of 154
Continued
Sub-item
Note
Reference
yes
Preset adjustment function
● In Legacy mode, the preset
adjustment function may only be
executed when the axis
concerned is at standstill
● Ensured the preset adjustment
function can not be triggered
unintentionally
● After execution of the preset
adjustment function, the new
position must be checked before
restarting
● Chapter
Preset adjustment function
(PNO profile), Page 87
● Chapter
Preset adjustment function
(TR profile), Page 118
● Chapter
Preset adjustment function
(legacy profile), Page 130

Device replacement
● Ensure that the new device
corresponds to the replaced
device
● All affected safety functions must
be checked
● Safety Manual (checklist
part 1 of 2)
● Chapter
PNO profile
parameterization,
from page 76
● Chapter
Parameterization TR-profile,
from Page 101
● Chapter
Legacy-profile
parameterization,
from Page 125.
