TR-Electronic CDV582 - Instance 121: Safety Input

Printed in the Federal Republic of Germany  TR-Electronic GmbH 2019, All Rights Reserved
11/21/2019 TR - ECE - BA - GB - 0139 - 02 Page 45 of 154
6.2.3.1 Parameter initialization (PNU 65005_0-1)
Alternatively, this parameter can also be set during operation via an acyclic parameter access to
parameter control PNU 65005 Bits 0-1, see Page 62.
Selection
Value
Description
Default
PRM Data Block
0
The measuring system is initialized during startup with the
parameters from the parameter data block of the measuring
system. The settings are adopted in accordance with
Chapter “Configurable module-related parameters” on
Page 43.
X
RAM Data
1
The measuring system is initialized during startup with the
parameters from the non-volatile RAM area of the
measuring system.
6.2.3.2 Parameter Write protection (PNU 65005_2-4)
Alternatively, this parameter can also be set during operation via an acyclic parameter access to
parameter control PNU 65005 Bits 2-4, see Page 62.
Selection
Value
Description
Default
Write all
0
Write access to all parameters which can be configured via
an acyclic parameter exchange (PNU 9xx, 6x xxx).
X
Read-only
1
Parameters PNU 9xx and 6x xxx are read only.
6.2.3.3 Write protection PNU 65005_5 (control) / PNU 971 (save)
Alternatively, this parameter can also be set during operation via an acyclic parameter access to
parameter control PNU 65005 Bit 5, see Page 62.
Selection
Value
Description
Default
Write all
0
Write access to parameters PNU 65005 and PNU 971
X
Read-only
1
Parameters PNU 65005 and PNU 971 (save parameters) are
read only
6.2.3.4 Write protection (PNU 65005_6), Param. Reset (PNU 972)
Alternatively, this parameter can also be set during operation via an acyclic parameter access to
parameter control PNU 65005 Bit 6, see Page 62.
Selection
Value
Description
Default
Write all
0
Write access to parameter PNU 972 (device RESET)
X
Read-only
1
Parameter PNU 972 is read only