Wiring Inputs and Outputs to the GCM
iSTAR eX Installation and Configuration Guide 4–23
Wiring Inputs and Outputs to the GCM
This section contains diagrams showing how to wire inputs and outputs to
the iSTAR eX GCM.
There are 16 inputs available on the GCM. Each pair of inputs share a
common pin, as shown in Figure 4.16.
Figure 4.16: iSTAR eX Inputs
Wiring Inputs to the iSTAR eX GCM
This section contains these diagrams:
Wiring NC and NO Double Inputs (1K, 5K, 10K), shown in Figure 4.17
Wiring NC and NO Single Inputs (5K, 10K), shown in Figure 4.18
Wiring Non-supervised Inputs, shown in Figure 4.19
Wiring Double Inputs to Common, shown in Figure 4.20
NOTE
For UL compliant installations, non-supervised inputs are not allowed.
To Next Page
Loading...
