Tyco iSTAR eX - Refreshing Controller Information; Setting ICU Options

Refreshing Controller Information
iSTAR eX Installation and Configuration Guide 5–13
Refreshing Controller Information
To refresh controller information in the ICU window, use any of the following
methods:
 Click the Refresh icon ( ) on the ICU toolbar. This method refreshes
information for all controllers in the utility’s subnet.
 Choose Refresh List from the View menu. This method refreshes
information for all controllers in the ICU’s subnet.
 Select a controller in the ICU window, right-click, and choose Refresh
from the pop-up menu. This method refreshes information only for the
selected controller.
 Set a refresh interval to automatically refresh the ICU window. See
“Setting a Refresh Interval” on page 5-14.
Setting ICU Options
To access the ICU Options dialog box, shown in Figure 5.5, select File>
Options from the ICU menu bar.
Use the ICU Options dialog box to:
 Enable and specify a refresh interval to automatically refresh the ICU
window.
 Change the password for the ICU.
 Specify the public IP address of the PC being used to download firmware
to iSTAR eX controllers.
 Set the download port on the PC being used to download firmware to
iSTAR eX controllers.
NOTE
Setting an automatic refresh interval increases network activity.
NOTE
Setting an automatic refresh interval increases network activity.