iSTAR eX Tools
iSTAR eX Installation and Configuration Guide 1–25
iSTAR eX Tools
The following sections describe the configuration and diagnostic tools
available for iSTAR eX hardware.
ICU
The ICU lets you set the initial parameters for iSTAR eX controllers.
The ICU runs on any Windows computer and provides the ability to:
Display the status and type of controller
Configure IP address and connection information for master and member
controllers.
Modify identity information for controllers, for example, changing a
member to a master controller.
Run configuration tools, like Ping and Ping Scan.
Activate the Real-Time Monitor that displays diagnostic information.
Run web-based diagnostics.
Verify host settings.
Download new firmware to multiple controllers.
Set the public IP address of the PC running the ICU for firmware
downloads.
Set the port to use for firmware downloads.
Restore default certificates.
Request certificate signing.
NOTE
The ICU has not been evaluated by UL.
To Next Page
Loading...
Need help?
General
