STAR eX Diagnostic Tests
7–8 iSTAR eX Installation and Configuration Guide
STAR eX Diagnostic Tests
iSTAR eX firmware provides diagnostic information for:
Readers
Cards
Outputs
Inputs
Serial (RS-232/RS-485) ports
Ethernet ports
Use rotary switch SW1 to activate diagnostic tests. Diagnostic information
displays on the iSTAR eX LCD. You do not have to configure C•CURE o run
diagnostic tests.
NOTE
Diagnostic tests add overhead to iSTAR eX processing, and may degrade
system performance. When the diagnostic tests are complete, deactivate
the test by resetting SW1 to display status information.
To Next Page
Loading...
