Configuring SNMP
5–32 iSTAR eX Installation and Configuration Guide
6. Click OK to save your configuration and close the SNMP dialog.
Rights Set the access right for the specified community. When an
SNMP message is received by the Controller, it is evaluated
based on these rights.
No Access – The SNMP message from a management
system in this community is discarded.
Read Only – Only GET, GET-NEXT, and GET-BULK
requests are processed. SET requests are not processed
from this community.
Read Create – SET, GET, GET-NEXT, and GET-BULK
requests are processed.
SNMP Trap
Manager IP
Address or Host
Name
Enter the IP address or host name of the SNMP Trap
Manager for this iSTAR Controller.
SNMP Hosts Accept SNMP packets from any host – Select this option if
you want the iSTAR controller to accept SNMP messages
from any host.
Only accept SNMP packets from this Host – Select this
option if you want the iSTAR controller to accept SNMP
messages from a specified host only.
IPAddress or Host Name – Specify the IP address or host
name of the SNMP Host for this iSTAR Controller.
Contact Specify the snmp-contact, a 1- to 64-character string usually
containing an emergency contact name and telephone or
pager number.
Location Specify the snmp-location, a 1- to 64-character string
usually containing location information about the Controller.
Table 5.10: SNMP Dialog Box Field Descriptions (Continued)
Field Description
To Next Page
Loading...
