Ultrasonix SonixTablet - Power Cord(S); Barcode Reader; Wireless Adapter (When Connected Externally)

SonixTablet Service Manual 00.053.129, Revision C Chapter 11: Maintenance
11-3
11.2.3 Power Cord(s)
Apply a small amount of one of the following recommended cleaning solutions to a soft, non-abrasive cloth and
wipe the power cord:
• water
• mild detergent (PH level at or near 7) and water solution.
11.2.4 Barcode Reader
Apply a small amount of one of the following recommended cleaning solutions to a soft, non-abrasive cloth and
wipe the barcode reader:
• water
• mild detergent (PH level at or near 7) and water solution.
11.2.5 Wireless Adapter (When Connected Externally)
Apply a small amount of one of the following recommended cleaning solutions to a soft, non-abrasive cloth and
wipe the wireless adapter:
• water
• mild detergent (PH level at or near 7) and water solution.
Cautions:
Power off and unplug the system prior to cleaning.
DO NOT apply cleaning solutions directly to the power cord.
Warning: Disconnect the barcode reader prior to cleaning.
Caution: DO NOT apply cleaning solutions directly to the barcode reader.
Note: Barcode reader usage should not entail patient contact.
Warning: Disconnect the wireless adapter prior to cleaning.
Caution: DO NOT apply cleaning solutions directly to the wireless adapter.
Note: Wireless adapter usage should not entail patient contact.