Uson SPRINT LC - Flow Test Parameters; Flow Test Setpoints

Page 113
Flow Test Parameters
Parameters in a flow test—
 Test Pressure
 Pressure Error
 Coupling Time (if external fixtures are used)
 Fill Time (only required on large products)
 Test Time
 Dump (auto, off or time)
 Max Flow (maximum flow)
 Min Flow (minimum flow)
 Next Program
Protect the Flow Sensor
Do NOT run a flow test unless product is attached to
the test port. Without this restriction, the high flow rate
could damage the flow sensor.
FIGURE 53
!
Fill Test
Zero
Couple
Flow Test Set
p
oints
TIME
PRESSURE & FLOW
Min Flow
Max Flow
T
est Pressure
(- P ERR)
(+ P ERR)
Flow and Pressure are compared to
Pass/Fail limits at the end of the test.