Page 28
Turn Power On
Startup Display
The first menu displayed immediately after power up is depicted below.
The menu shows the revision level of the firmware, the main options
installed, the company the tester was built for, and the tester serial
number.
For questions about a particular Sprint
LC tester, please obtain the serial
number and revision level of the
firmware before contacting Uson. This
information will help Uson technicians
to provide the most effective help.
Figure 9
Run Display
After the startup display, the next display looks like that shown in
figure 10. We call this the run display.
The run display shows test and setup
information to operators during all
tests.
For more information on the run
display please refer to the quick setup
section on pages 12 through 17. It is
explained in detail there.
Figure 10
SPRINT TEST S/W REV. 3.XX
PRESSURE DECAY, OCCLUSION
COMPANY NAME
SERIAL NUMBER: 12345-1S
Any button to continue...
PD 3.0
Mode Test Time Status
PROGRAM 1
Test Press. Tested Reject
15.000 psig 0 0
To Next Page
Loading...
