Page 134
Engineering Section
Contents:
• Calibration Setup
• Pressure Calibration
• Flow Calibration
• Engineering Data and Physical Laws
Attaching Sprint LC to a fixed surface
Uson recommends using the feet attaching threads when mounting Sprint
LC to a surface or machine. The Sprint LC base has four #6 by 32
attachment points. The rubber feet are typically left on to act as a cushion.
Calibration
The Sprint LC uses firmware calibration.
DO NOT enter calibration mode unless
entering accurate new calibration data to
linearize the pressure or flow transducers.
10.66 in
To Next Page
Loading...
