Page 88
Programming
Introduction
Now you’re ready to enter times and limits into programs.
Sprint LC comes with ninety-nine factory-installed programs with default
parameters. Keep them or change them to suit the testing situation. Please
note that not all test types are available in every tester.
Factory-installed programs—
f Program 1 Pressure Decay
f Program 2 Occlusion
f Program 3 Flow
f Program 4 Burst
The factory-installed programs can be modified in any way. For instance,
it is possible to set up all programs to measure flow, if desired.
Values stored in factory-installed programs need to be modified to the
particular product. Use the preset values as a convenient starting point in
programming if that helps.
This section explains how to program six types of tests:
• Pressure Decay
• Occlusion
• Flow Measurement
• Leak Check using Flow
• Burst
o Creep (a subset of burst testing)
• Crack (similar to burst testing, but with two sensors)
To Next Page
Loading...
