Appendix F
Pass/Fail Jumps
The Sprint LC tester described in this Appendix has additional control to
link the test programs together based on either an accept or reject
condition. This feature also adds the option to pause the test sequence
between linked test programs. The Next Program line in the Test
Parameter menu is modified to have a sub-parameter pop-up menu. See
page 52 for more information on the standard Next Program feature.
Next Program Sub-Parameter Menu
The Test Parameter menu is modified to have a sub-parameter menu for
the Next Program line. Press the INCREMENT keypad (GoTo) to access the
pop-up menu. See the figure on the next page.
On Pass vs. On Fail
The four settings are separated into two groups On Pass and On Fail. The
two lines associated with On Pass control actions that are only executed if
the part passes and the test is accepted. The two lines associated with On
Fail control actions that are only executed if the part fails and the test is
rejected.
On Pass/Fail (Next) Program
The two Program lines determine the next program to be run at the
completion of the current program. If the value is set to zero the test
sequence will end.
Appendix 17
To Next Page
Loading...
