Page 80
Start Data Logging
Press the ENTER/BACK keypad while the tester is idle in run mode to enter
the Run Mode Functions menu. Select Print Header and press ENTER/BACK
to get a report header at the start of a report. The test result data are
automatically sent to the RS-232 port. This information can be captured by
a computer or printed by a printer.
Parameter List and Test Result Heading
Shown below is an example of the information that will appear at the start
of the data logging report. In this example, program 1 is not linked to any
other program.
**************************************************************************
TESTER # 12345-1S SET-UP PARAMETERS PROGRAM 1 TEST TYPE: PD
Test Press : 10.000
Press Error : .500
Coupling CP1
Timer 1 : .5 ON
Hold/Fail : NO
Fill Time : 2.0
Stab Time : 1.0
Test Time : 3.0
Dump : AUTO
Next Program : 0
Reject Level : .050
Product Vol : 0
**************************************************************************
Cycle Prog Test Value Units Result
The current selected program is printed first, followed by additional linked
programs. For example, if the current program is program 1, and 1 is
linked to 2, and 2 is linked to 5; then the header will contain information
for program 1, 2, and 5.
The example on the following page shows both programs 1 and 2 because
they alone are linked together.
To Next Page
Loading...
