Uson SPRINT LC - Programming a Crack Test; Crack Test Fail

Programming a Crack Test
Use the procedure called Programming a Burst Test in the Sprint LC
Owner’s Guide to enter values for a crack test. The parameters of a crack
test are set in the same manner as a burst test. See page 128.
Crack Test Fail
(
Pressure too hi
g
h
,
HIGH crack
)
FIGURE 101
TestVent
Delay
Zero
Zero
Sensor 2
(downstream)
Sensor 1
(upstream)
Min Burst
Max Burst
Test ends when
Max is exceeded
No Event
T
IME
Pressure
Press. or Flow
Appendix 25