Uson SPRINT LC - Page 182

Procedure
To enter a new program name follow the procedure below. More
information on how to connect to the serial port may be found in the
Sprint LC Owner’s Guide on page 70 and 72.
1
.
2
.
3
.
4
.
5
.
6
.
1
1
.
.
Connect the Sprint LC to a host computer and use a terminal
program such as Window’s “Hyper Terminal” to open the serial
port. See page 77
2
2
.
.
When the key is turned to the program mode the tester prints the
following message over the serial port:
Type 'P' to Edit Program Names...
3
3
.
.
The program name option is selected by typing the letter “P”.
Sprint LC responds by asking for the program number.
Select the Program Number to rename (1-99) or 0 to Quit:
4
4
.
.
The program number is typed in followed by “Enter”. The Sprint
LC then asks for the program name. (If a value is typed in that is
not valid the same line asking for the program number is printed
again.)
Enter new Program Name (24 Chars. Max): _
5
5
.
.
The name is typed in followed by “Enter”. The Sprint LC renames
the program and requests another program number.
Select Program Number to rename (1-99) or 0 to Quit:
6
6
.
.
Any number of program names may be changed before exiting.
Enter zero and type “Enter” to exit.
Appendix 22