Vaisala AWS330 - Telemetry Parameters

Chapter 5 __________________________________________ Software Configuration and Operation
VAISALA______________________________________________________________________ 127
1012-163
Figure 76 Setting EMAIL Parameters
Table 28 eMail Transmission Parameters
Set Name Parameter Name Use
EMAIL server Name or IP address for the operator SMTP
server
EMAIL recipient Recipient eMail address
EMAIL sender Sender eMail address
(1
EMAIL auth Authentication type to use
(2
none = No authentication
plain = Authentication mode 'plain'
login = Authentication mode 'login'
1)
eMail servers usually check that domain part in sender address is a
known domain name, and reject messages from fake domains.
2)
See below for instructions on how to set credentials.
If other authentication mode than none is selected, credentials have to be
created through the logger's service interface as follows:
1. Start AWS Client software (Start - All Programs - Vaisala -
Vaisala AWS Client) and connect to the logger.
2. Open service connection by selecting from the menu Maintenance
- Terminal Connect.