DME Admin Guide 113
Chapter 8
Input Stream Configuration
Flash/RTSP Pull
To access the Flash/RTSP Pull fields:
1. Navigate to
Input Configuration > Flash/RTSP Pull.
Use this page to configure streams that will be pulled into the RTMP Multi-protocol server
on the DME. Both RTMP and RTPS streams are configured on this page.
As shown below the number of supported streams depends on the DME hardware you
purchased. See table below for the number of configurable input streams.
Field Description
Stream Name Name used within the DME to connect input and output streams. It
is possible to effectively retain the input stream name by making
stream name and Publishing Point names the same or changing the
stream name to the name used within the DME. In some cases, the
publishing point names may be cryptic as is typically true if coming
from a CDN
Type • RTSP – pull the RTSP stream into the DME.
• RTMP – pull the RTMP stream into the DME.
Source IP/
Address:Port
Enter the IP address of the source server. Enter a port number only
if you are not using the default RTMP port (1935) or the default
RTSP port (554). If pulling RTSP from the RTP Streaming server,
enter
127.0.0.1.
To Next Page
Loading...
General