198 © Vbrick Systems, Inc.
Playback Examples
Configure VBOSS for the DME
To send a stream from a Vbrick Encoder > VBOSS > DME > Flash client: (Example 1)
1. Configure an RTMP Transmit from encoder to VBOSS URL.
2. In the DME, configure
E to L (to pull the VBOSS URL).
3. Distribute as Flash:
vbrtsp://<dme_ipaddress>/live/<stream_name>
To send a stream from Vbrick Encoder > DME > VBOSS: (Example 2)
1. Configure an RTP Auto Unicast (
In-2) from encoder to DME.
2. Configure
RTMP Push (Out-9) to the VBOSS publishing point.
Configure Rich Media Desktop (RMD) for the DME
Requires RMD 1.1 or higher.
You can use RMD to send a Flash (RTMP) stream to the DME. To configure a a Flash
stream, launch RMD, go to Broadcast > Broadcast Settings, and configure the following page
with the values shown below. (As shown in the example, "live" is the default application name
for the DME.)
You will also need to click
Set Credentials and enter the User Name and Password for the
DME's
Stream Input Authentication user (default = broadcast | broadcast). When done, go
to Broadcast > Start/Stop Broadcasting to start streaming to the DME.
You can then use any of the DME output methods to redistribute the stream. See
Configure
a DME Stream for details.
VEMS Mystro
(Live Entered URL)
RTMP rtmp://<dme_ipaddress>/live/<stream_name>
RTP
vbrtsp://<dme_ipaddress>/filename.sdp
TS
vbricksys://<multicast_ipaddress>:port
HLS
http://<dme_ipaddress>/HLS/ <stream_name>/
playlist.m3u8
HLS
http://<dme_ipaddress>/HDS/ <master_playlist>.f4m/
RTP
Multicast
http://<dme_ipaddress>/<multicast_sdp_file.sdp
To Next Page
Loading...
General