VC Gateway Configuration
DME Admin Guide 159
To place an outgoing call to a videoconferencing system:
1. Make sure the Outgoing Line Details (including the
Destination Identity) are configured
correctly for the selected
Line Name.
2. Click the
Call button for the selected Line Name on the Outgoing Lines page.
3. Verify the State is "
connected" on the Outgoing Lines page.
4. Verify you have audio and video on the videoconferencing monitor or your desktop.
5. If a Live Entered URL is configured in VEMS Mystro, verify the stream is present.
Cre ate or Edit a VC Gate way Outg oing Line
To create or edit a VC Gateway Outgoing Line:
1. Navigate to
VC Gateway Configuration > Outgoing Lines.
2. Click
New to create a new line or Edit to edit an existing line.
The
Outgoing Line Details page shows parameter details for outgoing lines. The parameters
shown on this page are identical to those on the Incoming Line Details page except for the three fields
explained below. In most cases you can use the values specified on the
Defaults page. Click on
the
Default button to set or reset to the defaults.
Field Description
Page Refresh Interval Select a refresh interval from the dropdown or
Never (not
recommended).
Line Name User-configured line name. Default =
OutgoingLine<n>
State Displays various descriptive messages indicating the current "state"
of the line. The first connected line will display as
connected;
additional connected lines will display as
bridged.
Edit
Edit | New. Click to create a new line or to edit an existing line.
Delete Click and confirm to delete a line.
Line
Call | Hang Up. Click Call to initiate a videoconference with the
configured endpoint or Hang Up to end the call.
Record Click to record the VC Gateway stream on the configured VEMS
Mystro server.
Default Use with care. This button will delete all lines in the table.
To Next Page
Loading...
General