80 © Vbrick Systems, Inc.
Sy ste m Re s e t
To access the Reset button:
Navigate to
System Configuration > General > System Reset.
The Apply, Revert, and Default Buttons
Reset the System
Streaming
To access the Streaming fields:
1. Navigate to
System Configuration > Streaming.
This page is used to set various configuration constraints. Be aware that it is possible to
overload the DME. That is, you can configure the maximum number of RTP connections
(and the maximum throughput) in such a way that performance will be seriously degraded.
If this happens, all clients will be affected and some connections may actually be rejected.
Guidelines for choosing the number of connections depend on the model number (shown on
the System Configuration >
General page) of your DME. For best results, use the
recommendations shown below.
Daylight Saving Time U.S. only. Check this box and the appliance will automatically
adjust for Daylight Savings Time. This is particularly useful when
monitoring the System Logs.
Button Description
Reset Resets (i.e. reboots) the appliance. A reset does not change, save,
or reset any configuration parameters.
Field Description
To Next Page
Loading...
General