18 © Vbrick Systems, Inc.
A typical login URL would have the following format:
http://172.22.2.50:8181
VBAdmin
VBDirectory
DME Status (Snapshot)
Lo g O u t o f th e DME
To log out of the application, click Log Out in the navigation panel on the left. As a security
measure, if no keyboard activity is detected for 20 minutes, VBAdmin will automatically
timeout and display the Login page.
It is highly recommended that you use the
Username and Password page in VBAdmin to
change the user name and password after logging in for the first time. The user name and
password cannot exceed 20 characters.
En d Us e r Lic e n s e Ag re e m e n t (EULA)
The first time you launch the DME you will need to page down and click on Accept EULA.
This means that you accept the end user license agreement for the Vbrick software. The
application will not run if you decline to accept the EULA.
Reg ister the DME
Note: Administrators should be aware that the DME’s management interface is
not on Port 80 as is typical for most web-based admin tools. By default the
admin port for the DME is 8181. This allows Port 80 to be reserved for
HTTP downloads.
Note: If you have purchased a hardware DME, it will come pre-registered
from the factory and you do not have to complete the registration steps
described in this section. These steps below are for software-only DMEs
only.
To Next Page
Loading...
General