128 © Vbrick Systems, Inc.
Transport Stream Out
To access the Transport Stream Out fields:
Navigate to
Output Configuration > Transport Stream Out.
Field Description
Multicast TTL Multicast streams are passed from router to router until a request is
serviced. This approach propagates the stream across organization
WANs. The Multicast TTL is a counter used to better control the
number of "hops" or passes between routers. Each router, unless
configured differently, decrements the multicast TTL (in the header) as
it is passed along. Once the TTL is zero, the packet is dropped. DME's
recommended default value is 63 – adjust as necessary to your needs
and network configuration.
Stream Name The input stream name you will be sending out as a transport stream.
Note: For MPEG-2 content, the Stream Name must be preceded with
“
mp2:” See MPG2TS Streams for more information.
Multicast/
Destination IP/
Address
If multicast output, the multicast address of the output stream, If
unicast, the destination IP address.
Port The port number you will be sending the stream to.
Announce Name (optional) If multicast, the program name to be included in the SAP for
this stream. If not filled in, Stream Name is used.
Enable Enable or disable the output transport stream.
To Next Page
Loading...
General