146 © Vbrick Systems, Inc.
Readonly Username and Password
To access the Readonly Password field:
1. Navigate to
User Configuration > Username and Password > Readonly User Management
section.
Use this page section to change the
Readonly user account password if desired. The Readonly
account user name and password (default for both =
readonly) is used specifically for read
only access to the DME server.
When logged in as a Readonly user, the user may only browse the DME interface. No
modifications may be made.
Username and Password
Stream Input Authentication
To access the Stream Input Authentication fields:
1. Navigate to
User Configuration > Stream Input Authentication.
Use this page to configure a “broadcast” password that will allow you to publish streams to
this server. This password is needed when sending a stream via auto unicast to a DME using
either In-2 or In-3 or when sending an RTMP stream from a live encoder to the DME In-1.
Caution: Be aware that you must know the current Administrator
User Name and Password to change the Readonly password.
Further, while you may change the password for the Readonly
account, the User Name will always be the default, “readonly”,
and may not be changed.
Field Description
Current Administrator Enter current Administrator user name.
Current Administrator
Password
Enter current Administrator password.
Readonly User New
Password
Enter new Readonly password.
Re-enter New Password Re-enter new password and be sure to click
Change Readonly
Password.
To Next Page
Loading...
General