VBrick dme - Stream to the DME with RMS 1.3

To Next Page

To Previous Page

Configuring Devices for the DME

DME Admin Guide 203

5. When done click OK and Finish and the H.264 for Flash option will be added to the

Outputs menu as a selectable output option.

Stre am to th e DME w ith RMS 1.3

You can use RMS to send an H.264 unicast push or a multicast output stream to the DME.

With both methods you will need to publish the .sdp file to the DME

 To configure an RMS stream for a DME:

1. Open RMS and enter a destination address on the Broadcast page. In the

Destination

Address field (Figure 1) enter a multicast IP address (for example 239.2.127.254) or the

unicast IP address of the DME.

Note: When entering metadata (e.g. Session Info, Origin E-Mail, etc.) be sure to remove

any leading spaces.