204 © Vbrick Systems, Inc.
Figure 1. RMS Broadcast Options (Part 1)
2. Extract the .sdp file. Once the session is active, the .sdp file is automatically created (in
the specified folder) by “enabling” the broadcast and name the file using the SDP File
Name().
Figure 2. RMS Broadcast Options (Part 2)
3. Verify the .sdp file. When creating an .sdp the information in the file is sourced from the
Broadcast page in RMS. Be aware that any leading spaces (see line 3 below), will cause the
.sdp file to fail when published to the DME. For this reason, be sure to delete leading
spaces before publishing.
To Next Page
Loading...