DME Admin Guide 167
Chapter 13
Logging
Enable Error and Access History Logging
The Error Log on the Monitor > Error Log page displays DME status messages as well as
errors.
Access History on the Monitor > Access History page shows files that have been accessed
since the last reset.
The
Logging page specifies logging rotation and overwrite rules.
To specify logging rotation and overwrite rules:
1. Navigate to
Logging > Logging.
Field Description
Roll Logging Check to enable the Error Log and/or the Access History rotation per
the
Roll log defined settings. If this box is not selected, logging is still
enabled but it will continue to accumulate into individual log files
rather than being rotated per the roll log settings defined below.
Logged entries are shown the respective
Monitor pages. The error log
displays DME status messages as well as errors. The access log shows
files that have been accessed since the last DME reset.
Roll log Overwrite the logs every
nnn KB or every nnn files (whichever comes
first).
Remote Logging The DME can provide remote logging of system services. Use this
checkbox to enable and disable the service.
Remote Server
Address
Please provide the remote server IP/FQDN address here.
Remote Server Port Please provide the remote server port here; 514 is default.
To Next Page
Loading...
General