Getting Started
DME Admin Guide 29
DME Status Bar
The DME Status Bar on the bottom of the VBAdmin page provides near-real time updates
and reporting on DME functions. The values on the bar update every two minutes or you
may use the
Refresh link to update them manually as needed. The different sections and what
they mean are described below.
Disable Server button. Click to enable or disable streaming on the DME and
terminate all connections. The “Server is Running” message will be replaced
with “Server is Idle.”
Displays DME information specifics:
• DME name and IP Address
• DME software version currently installed
• MPS software version currently installed
• Total up time since the last server reset
• MPS and RTP Server status (True means running.)
Server status. The “Server is Running” message will change to “Server is Idle”
if the Disable Server button is toggled. The field’s background color will
change indicating its health status. The server status (Normal, Warning, and
Alert) is tied to Content Disk, CPU, Throughput and Memory status – any
elevation of these statuses will be reflected in this status.
Server status. This section will also display “Server is Upgrading” during the
upgrade process and report upcoming licensing expirations.
This area displays the number of streams going through your Multiprotocol
server, your stream capacity, and associated CPU usage. This covers your
RTMP, RTMFP, HLS, and HDS streams.
This area displays the number of streams going through your RTP server, your
stream capacity, and associated CPU usage.
To Next Page
Loading...
General