136 © Vbrick Systems, Inc.
Cre ate or Edit an RTP Relay
To create or edit an RTP Relay:
1. Navigate to
Output Configuration > RTP Relay.
2. Click
New Relay to create a new relay or the relay name and then Edit Relay to modify an
existing relay. Complete the fields described below as required.
Source Settings
These settings describe the source of the stream to be relayed. It can be sourced internally
from the DME (127.0.0.1) or it can be fetched from elsewhere. You can also wait for it to be
announced. The dominant use case is to source the stream internally from the DME.
Field/Hyperlink Description
Relays Shows all defined relays.
New Relay Creates a new relay.
Edit Relay Edit the selected relay.
Delete Relay Delete the selected relay.
Field Description
Relay Name Enter a unique relay name.
Status Check to enable. Remember to click
Apply before you exit the page.
To Next Page
Loading...
General