Detailed Use Cases
DME Admin Guide 193
Configure a Multicast Relay with an Auto-Unicast Source
The Vbrick Distributed Media Engine contains a fully featured RTP server, giving the
administrator the ability to provide an RTP Relay Multicast stream. When configured, clients
will then be able to join the multicast via HTTP to the DME. This example shows how a relay
can be streamed from an auto unicast source on a Vbrick H.264 encoder.
H.264 Encoder Setup
1. Configure the encoder with a valid Auto Unicast (TCP) stream and then navigate to
Program Configuration > Transmitters and configure a transmitter to unicast to the
DME.
2. Configure the transmitter with the following settings:
a. Set the Auto Unicast Dest Port to the RTSP port of the DME.
b. Configure the
Auto Unicast Dest Pub Point Name to the desired sdp file name. This
.sdp file will be automatically placed in the root folder. (Note: The file name must be
appended with .sdp or the auto unicast will fail.)
c. Enable the transmitter and verify it is sending to the DME.
DME Setup
1. Create a new RTP Relay. See: Create or Edit an RTP Relay.
To Next Page
Loading...
General