114 © Vbrick Systems, Inc.
RTP Playlists
RTP Playlists make it possible to send stored .mp4 (Part 10) VOD files as live streams. They
can consist of a single file or multiple files and can be reordered and concatenated into a
single playlist. They can also be weighted and played in differing modes; for example, they
can be looped or played sequentially.
You can then use a playlist to create a multicast relay using the .sdp file, i.e. the
Mount Point.
For more about this scenario, see
Out-7 > Relay (Unicast/Multicast).
To launch a playlist, you can use it in an RTSP URL by specifying the .sdp file name or you
can use it to create an RTP Relay.
Application Only required if you are pulling RTMP. This string is defined by the
source. For example, on a Vbrick encoder, this string corresponds to
the
RTMP Application value on the Program Configuration >
Transmitters page. Valid strings are limited to:
live, vod, vbrick, and
vbApp.
Publishing Point This is Publishing Point Name on the source server. If the source
is a Vbrick encoder, use the
Resource Name on the Program
Configuration > Servers page on the encoder.
User Name Required if client-side authentication is required by the source
server.
Password Required if client-side authentication is required on the source
server.
Use RTCP Default =
Enabled. RTCP server reports assist maintaining audio/
video synchronization for some players. Uncheck if your server does
not generate RTCP reports of if you wish to ignore RTCP reports
from the source.
Enable Use this dropdown to enable or disable the stream. All streams are
disabled by default.
Status Read only: Disabled | Connected | Receiving.
DME Model Number of Configurable Input and Output Streams
7530 25
7550 35
7570 60
Field Description
To Next Page
Loading...
General