200 © Vbrick Systems, Inc.
Stre am to th e DME w ith RMS 1.6
Stream to the DME with an RTP Auto-Unicast Push
To configure an RMS stream for a DME:
1. Open RMS and enter a destination address on the Broadcast page. In the
Destination
Address field enter the unicast IP address of the DME.
2. Change the source port to a legal port number that is unused on the source RMS.
Figure 1. RMS Broadcast Options (Part 1)
Note: When entering metadata (e.g. Session Info, Origin E-Mail, etc.) be sure to remove
any leading spaces.
To Next Page
Loading...