System Configuration
DME Admin Guide 73
Ports
To access the Ports fields:
1. Navigate to
System Configuration > Ports.
Field Description
RTSP Server Port Default = 554. RTSP port for VOD streams from RTP
server. Cannot be changed. Used to receive an RTP Auto
Unicast stream as input and to serve RTSP RTP clients for
output
MPS Server Port Default = 1935. MPS Server Port for Flash VOD streams
from MPS server. Allows MPS streams as input. For example
a Vbrick H.264 encoder can be an MPS input stream.
Note: This was formerly labeled the RTMP Server Port.
Multi-Protocol Server RTSP
port
Default = 5544. The port number used by the Multi-Protocol
Server to listen for announcements.
RTMP Server Announce
Listener Port
Default = 5544. Allows for listening for auto unicast sessions
from RTSP clients. Lets you send RTP streams to an RTMP
streaming server via Auto Unicast (for transmuxing to Flash,
HLS, or TS). Also allows TS streams to be served via RTSP
on this port.
VBAdmin Server Port Default = 8181. Specifies the listener port for HTTP
management connections as follows:
http://IPaddress:port
where
IPaddress = DME IP address or hostname, and port.
The port number can be moved to another port if required as
long as it does not conflict with another existing port in the
system.
Conversion Input Port Start Default = 64879. The starting port number used by the
Stream Conversion feature.
Secure VBAdmin Server Port Default = 8383. Specifies the listener port for management
and HTTPS connections. Used for HTTPS connections
when enabled on the
Security configuration page. Can be
moved to another port number if required.
To Next Page
Loading...
General