Getting Started
DME Admin Guide 33
Once you have logged into the SSH Admin Interface, the tool will first perform a quick
review of the CPU and Memory configuration. In most cases, the review takes less than 1
second and you will not see anything. However, if the DME does not have sufficient CPU (by
count) or Memory resources (by percentage, anything below 80% will be reported), then the
interface will provide an upfront message. The message will also identify possible false-
positive cases for early versions of hardware DMEs. Messaging will appear similar to the
image(s) below:
Caution: As a reminder, the DME ships with admin|admin as the username and
password. Be sure to change this on the DME User Configuration > Username and
Password screen. This should be done BEFORE allowing internal/external access to
the DME.
To Next Page
Loading...