38 © Vbrick Systems, Inc.
Reset Tasks
Reset to Default Settings This task resets most settings (except for network settings and
passwords) to their default settings. The same task may be
executed from the
System Configuration > Manage Configuration
form in the DME.
This task requires a system reboot. Please do not reboot during
any upgrade activity (identified at the top of the screen).
Reset to Factory Default
Settings
This task resets ALL settings (including network and passwords)
to factory defaults. Use with caution. The same task maybe be
executed from the
System Configuration > Manage Configuration
form in the DME.
This task requires a system reboot. Please do not reboot during
any upgrade activity (identified at the top of the screen).
Remove License This task will remove Vbrick DME licenses. This will require you
to acquire and reapply a new license (or any license you may have
saved) to the DME for proper operation.
This task requires a system reboot. Please do not reboot during
any upgrade activity (identified at the top of the screen).
Realtime
Usage
Tasks
Realtime System Usage
Snapshots
This task, using the Linux application sar, will provide usage
snapshots for CPU, Memory, Paging System, SWAP, and DISK.
These results are only snapshots and do not provide trending.
Please review online Linux documentation for sar command for
details on particulars of reported data.
CPU Realtime Usage This task, using the Linux application sar, provides a 20 reports at
3 second intervals (1 minute total) of CPU use within the DME.
This is meant to be a more detailed view than the snapshots, but
only report for the minute selected.
Control-C will terminate the report.
Please review online Linux documentation for sar command for
details on particulars of reported data.
Memory Realtime Usage This task, using the Linux application sar, provides a 20 reports at
3 second intervals (1 minute total) of memory use within the
DME. This is meant to be a more detailed view than the
snapshots, but only report for the minute selected.
Control-C will terminate the report.
Please review online Linux documentation for sar command for
details on particulars of reported data.
Disk Realtime Usage This task displays the disk partitions and usage for attached disks,
the last SMART report (if the DME is hardware), and using the
Linux application sar, provides a 20 reports at 3 second intervals
(1 minute total) of disk use within the DME. This is meant to be
a more detailed view than the snapshots, but only report for the
minute selected.
Control-C will terminate the report.
Please review online Linux documentation for sar command for
details on particulars of reported data.
Group Administration Task Description
To Next Page
Loading...
General