Videonics PTM-1 - Marking Pages and Lines; Shortcuts for Marking Items; Working with Marked Text

Chapter 7 Working with Titles and Lines
83
To change the location of the markers:
1 Move the cursor to the position where you want to set the
marker.
2 Press
MARK START to change the start marker, or press MARK
END to change the end marker.
To remove a set of markers:
♦ Press UNDO.
Marking Pages and Lines
To copy, move, or otherwise change an entire page, position the cursor
at the end of the preceding line, rather than at the beginning of the line
you want to mark. Placing the start marker at this location marks the
page header information for the page. When you subsequently copy or
move the marked text, the page header information accompanies the
page to its new location, thus preserving all page attributes (alignment,
transitions, duration, and so forth).
Likewise, to copy, move, or otherwise change an entire line or lines,
position the cursor at the end of the preceding line, rather than at the
beginning of the line you want to mark. This ensures that the line pre-
serves whatever text attributes (font, size, color, and so forth) have
been assigned. Otherwise, the line inherits the attributes assigned to
the line immediately above where it is moved or copied.
Shortcuts for Marking Items
To mark all text on the current page, press SHIFT+MARK START, then
SHIFT+MARK END.
To mark all text on all pages in a project, press
CMD+MARK START, then
CMD+MARK END.
Working with Marked Text
Once you mark a block of text, you can perform any action on the
block. You can delete the text, change its attributes, move it to a differ-
ent location, and so forth.