Personal TitleMaker User Guide
46
LESSON 7
CREATE PAGE SIX
Page six is another blank page, just like page four. See
if you can use what you’ve learned up to this point to
create the new page and copy its attributes from page
four. Some brief instructions follow.
1 Create the new page following page five.
2 Set the page’s in transition to a medium speed cut and set its
duration to infinite.
3 Set the page’s out transition to a medium speed cut.
LESSON 8
CHECK YOUR PROGRESS
You’ve now created half of the required pages for the tutorial. It’s a
good time to play back the pages in the project to see how you’ve
done. We recommend you read through all of the following steps
before you begin.
1 If your input device (camcorder) is not yet turned on, do so
now. If it is already running, rewind the tape to the begin-
ning, then roll it forward to the point where the first image
appears. Finally, put the device in Pause mode.
2 Press
CMD+PLAY. This instructs Personal TitleMaker to play
your project from the beginning — that is, from page one.
Your screen should be completely black at this point because page
one is completely black. Because page one’s duration is set to infi-
nite, this page remains on the screen until you manually invoke
the next page.
3 Press
PLAY to manually invoke page two.
blank
cmd
PLAY
+
To Next Page
Loading...