Watlow F4T User Manual

Watlow F4T Controller • 33 • Chapter 2 Configuration Using Composer
16. Click the OK button.
17. Click on the drop down button and ensure the folder is set for Read/Write capabilities as
shown below.
18. Click Share.
The graphic below shows the folder as being shared.
After the user account has been identified or created and the shared folder has been setup
it is time to configure the File Transfer function within the controller. The graphics below
show all fields that must be filled in to do an automatic transfer of the data logged file to the
shared folder identified in this example as SambaStore.
Note:
Transferring files via Samba may be accomplished by 2 methods; Auto-transfer, and a user
initiated transfer. Once the automatic transfer is enabled this function will move the file
to the remote computers shared folder whenever data logging is running and the set file
size has been reached. The graphics that follow illustrate automatic transfer.

Watlow F4T Specifications

General

Inputs	Thermocouple, RTD, mA, V
Outputs	Relay, SSR, mA, V
Communication	Ethernet, Modbus RTU
Data Logging	Yes
Certifications	CE, UL, cUL, RoHS
Control Modes	PID, On/Off
Power Supply	100 to 240 VAC
Operating Temperature	0 to 50°C
Enclosure Rating	IP65
Display	4.3 in. (109 mm) color touch panel LCD
Control Loops	Up to 4