Watlow F4T User Manual

Watlow F4T Controller • 18 • Chapter 2 Configuration Using Composer
Configuring Pluggable Flex Modules
This controller can have up to six Flex Modules (FM) installed in the chassis. The presence of
each FM must be confirmed and accepted using Composer
®
software. FMs can be fully config-
ured as installed hardware or the user can type in a valid FM part number for later installa-
tion. For more detail regarding the module installation process, see the Installation and Trou-
bleshooting User's Guide for the controller in use.
Note:
Typing in a valid part number without the presence of the module is intended for the sole
purpose of building the FBD (connecting function blocks on the canvas). Errors may be
generated and all outputs will be off until the module is inserted.
Topics discussed in this section follow:
Screen Orientation: detailed description of the Pluggable Module configuration screen and as-
sociated characteristics.
Symbols Related to Pluggable Modules: description of the symbols that may be displayed when
using Composer software.
Configuring Flex Modules: configuration process described.
Entering FM Information Before Module Installation: detailed description of the why and how
a user would do this prior to acquiring the module.
Note:
The graphic below represents a controller that first had its flex modules installed with the
controller then being connected to a computer. Because of this scenario each slot appears
with no expected modules. This screen and symbols that are displayed will look different
using a different scenario.
Navigate to Pluggable Modules screen:
1. From any screen click on the Device Menu tab to drop down a submenu.
2. Click the Pluggable Modules button.
Pluggable Flex Modules - Screen Orientation
①
Module Slot - Location
• The blue box (on the right)
and the slot highlight will
move with the mouse to bring
focus to the slot/module.
②
Use Detected Part Number
• Click this button to accept
the module that the system
sees as being present in the
slot and displayed in the field
identified as "Detected Part
Number".
③
Set Expected To None
• Click on the X to tell the system there will be no module installed in this slot. Taking

Watlow F4T Specifications

General

Inputs	Thermocouple, RTD, mA, V
Outputs	Relay, SSR, mA, V
Communication	Ethernet, Modbus RTU
Data Logging	Yes
Certifications	CE, UL, cUL, RoHS
Control Modes	PID, On/Off
Power Supply	100 to 240 VAC
Operating Temperature	0 to 50°C
Enclosure Rating	IP65
Display	4.3 in. (109 mm) color touch panel LCD
Control Loops	Up to 4