Faults 72800115 Markoprint X4JET
Seite 114 von 177 GB
Faults
The following chapter describes possible causes of malfunctions and how to remedy
these.
In case of frequent faults, reduce the service intervals depending on the actual work
load.
Please contact your local distributor with regard to faults that cannot be remedied
with the information provided below.
Safety
Staff
The fault remediation work described here, unless specified otherwise, can be
performed by the operator.
Some tasks may only be performed by specially trained specialised staff or
exclusively by the manufacturer; this is specifically pointed out in the description of
the individual faults.
Work on the electrical system may only be performed by electricians.
Electrical system
DANGER!
Danger to life through electric shock!
Danger to life if live components are touched. Electrical components that
are switched on may execute uncontrolled movements and cause severe
injury.
Therefore:
– Before starting any work, switch off the power supply and pull the
mains plug.
Improper fault remediation
WARNING!
Risk of injury by improper fault remediation!
Improper fault remediation may cause severe injury to persons, or material
damage.
Therefore:
– Ensure adequate working space before starting any work.
– Keep the working area clean and tidy! Loosely stacked or scattered
components and tools are potential causes of accidents.
To Next Page
Loading...
