Operation 72800115 Markoprint X4JET
Seite 93 von 177 GB
To set the zoom
The width of the print image can be varied with the zoom value. At a zoom of 100%, the
print image is printed 1:1 as displayed in the iDesign.
With this parameter a change in the size of the print image is achieved. If the parameter
is reduced the print image becomes narrower by delaying individual pixel gaps. This
compresses the pint image and enables the ink consumption to be reduced.
By printing of barcodes you must look out for print optimal with 300 dpi and 100%.
Other dpi values or an enlarging or narrowing can cause deformations.
With the standard setting the print image has the same width, irrespective of the
modified intensity (dpi).
100% = 1:1
Via WEB-interface or iDesign it is possible to select the “Fixed zoom”. The print image
will be print with all pixel, irrespective of the intensity.
The print image is in the width 1:1 with a resolution of 600 dpi.
With a resolution of 300 dpi, the print image is more than twice the width 1:2, caused of
the halved intensity.
Change the zoom to 10% - 900% with the iLOGIK. The value can be changed in 1%
steps.
Pay attention, that a widening or narrowing of barcode prints have the right measure.
Follow the chart!
Barcode width: Allowed Zoom factors with fixed zoom:
1 100 200 300 400 500 600 ...
2 50 100 150 200 250 300 350 ...
3 33 66 100 133 166 200 233 266 ...
4 25 50 75 100 125 150 175 200 225 ...
5 40 60 80 100 120 140 160 180 200 ...
6 33 50 66 83 100 116 133 150 166 183 ...
To Next Page
Loading...
Need help?
General
