Faults 72800115 Markoprint X4JET
Seite 122 von 177 GB
Rinsing and bleeding MX print head
CAUTION!
Pollution of the environment!
Please secure the environment against leaking ink by purging the TOP print
head!
Afterwards wipe the nozzle plate once with a lint-free cloth.
Rinsing:
There are no moving parts in the print head requiring regular maintenance.
However, for printing onto outer packaging (e.g. cartons, trays, sacks, etc.) it must be
expected that dust and fibre particles carried along are freed and adhere to the nozzle
plate of the print head. Over a period of time, this can lead to a worsening of the print
quality.
In this case, please precede the rinsing process.
Instruction
Please rinse the MX print head as follows:
Press the [PURGE] button on the system flange plate.
With a short push on the button it happen a flush run, the vacuum pump of the
maintenance station runs to suck off the ink rests. The vacuum pump runs after ca. 1
sec. shortly to rinse ink, air and dust from the nozzles, afterwards the vacuum pump runs
ca. 10 sec. to suck off the ink rests completely.
Bleeding:
Instruction
Please bleed the MX print head as follows:
Fig. 0-1: Switch the system on
Put the locking clamp on the nozzle plate.
To Next Page
Loading...
