Installation and initial operation 72800115 Markoprint X4JET
Seite 54 von 177 GB
Installation and initial operation
Installation and commissioning is normally performed by the manufacturer’s staff
or by persons authorised by the manufacturer.
After commissioning, the operator is instructed and trained by the operating
company.
Specialised staff can also assist if the location is changed after commissioning.
Safety notes for installation and initial operation
Staff
Installation and commissioning may only be performed by specially trained staff.
Work on the electrical system may only be performed by electricians.
Personal protective equipment
Wear the following protective gear when performing installation and commissioning
tasks:
Protective clothing
Safety shoes
Safety gloves
Electrical system
DANGER!
Danger to life through electric shock!
Danger to life if live components are touched.
Therefore:
– Switch off power supply and secure against switching before starting
any work.
Improper installation and commissioning
WARNING!
Risk of injury due to improper installation and commissioning!
Improper installation and commissioning may lead to severe injury to
persons or material damage.
Therefore:
Ensure adequate assembly space before starting any work.
– Handle exposed sharp-edged components with care.
– Keep the assembly area clean and tidy! Loosely stacked or scattered
components and tools are potential causes of accidents.
– Secure components to prevent falling down or falling over.
To Next Page
Loading...
Need help?
General
