Operation 72800115 Markoprint X4JET
Seite 76 von 177 GB
Operation
Switch on / Switch off
Fig. 36: On-off switch on the back of the system
Switching on
1. For switch on the system activate the switch on the back.
The controller must conduct a self-test and briefly indicates the unit version number after
the company logo has passed through the display.
After approx. 10 seconds the status menu-1 appears on the display.
The configuration of the print technology must be set with the initial operation.
Here the system doesn’t boot up completely for now, first the configuration of the
print technology must performed.
(
Chapter Configuration of the print technology, page 74
CAUTION!
Material damages caused by an incorrect installation of the control
system!
With the controller switched on, a defect may occur in the system
electronics.
Therefore:
– Only install the controller if this is switched off.
– Network cables only connect or disconnect if the power supply is dead
voltage.
Switching off
1. For switch off the system activate the switch on the back.
2. With the use of MX print heads, these can be switched off on the maintenance station
separately. If the controller will be switched off, the print heads will also switch off, only the
maintenance station must be switched off separately.
On-off switch on the back of the
system
To Next Page
Loading...
Need help?
General
