Installation and initial operation 72800115 Markoprint X4JET
Seite 55 von 177 GB
Installation
Controller installation
IMPORTANT: To prevent faults due to potential differences, an electro-conductive
connection between control unit and conveyor belt must be established.
CAUTION!
Material damage due to improper controller installation!
With the controller switched on, a defect may occur in the system
electronics.
Therefore:
– Only install the controller if this is switched off.
– Network cables only connect or disconnect if the power supply is dead
voltage.
When choosing the installation location the following conditions apply:
Consider the generally accepted ergonomic criteria in accordance with workplace
ordinances as well as country-specific legislation.
The installation location must be a dry and dust-free room, ideally with an ambient
temperature of approx. 18…25 °C.
The installation location may not be subject to fast temperature fluctuations
(condensation!).
Do not set up the controller directly next to or above hot surfaces, since this will
affect cooling of the controller.
If the controller is operated on a tripod (accessory), the stability of the tripod on an
even foundation must be ensured.
The controller may not be exposed to flammable, explosive, corrosive gases or
chemical vapours.
The controller may not be installed in the vicinity of high voltage equipment or
power supplies.
The controller may not be subjected to direct vibrations or shocks.
Keep controller away from oil or water.
The controller may not be exposed to strong magnetic or electric fields.
To Next Page
Loading...
Need help?
General
