上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
9 / 131
1.5.3 Manual Control Area
It is used to move the machine tool manually.
Compared with sheet cutting configuration, B-axis is added in tube cutting
configuration. This part takes sheet cutting configuration as an example:
• Axis direction buttons
Used to move each axis towards positive or negative direction.
• Feed mode button
Used to switch among the following feed modes by clicking the circular button
in the middle:
– Jog mode
Including low-speed jog mode and high-speed jog mode.
Click an axis direction button. The machine tool moves at jog/rapid jog
speed until you release the button.
Click several axis direction buttons at the same time. The clicked axes
move at the same time at jog/rapid jog speed.
To Next Page
Loading...
