Maintenance
3403−1/A1
Winterthur Gas & Diesel Ltd.
9/ 9
4. Completion
1) Install the cylinder cover, refer to 2708−1.
2) Set to on the bearing lubrication pump.
3) Look through the scavenge ports on the fuel side. Make sure that the running
surface of the cylinder liner stays dry.
Note: A defective O-ring in the piston rod gland can cause an increase of the
dirty oil level in the scavenge air space.
4) Do a function check of the cylinder lubrication, refer to 7218−1, paragraph 1.2.
5) Remove all tool and equipment from the work area.
Piston: Removal and Installation
2016
To Next Page
Loading...