Maintenance
TOC
Table of Contents
RT-flex50DF
2016
Winterthur Gas & Diesel Ltd.
3/ 4
Connecting Rod
Loosening and Tensioning the Connecting Rod Studs 3303−1/A1....................................
Bottom End Bearing − Removal, Inspection and Installation 3303−2/A2...............................
Top End Bearing − Removal and Installation 3303−3/A2.............................................
Removal and Installation 3303−4/A2..............................................................
Top End Bearing − Bearing Cover Removal and Installation
3303−5/A2...............................
Crosshead
Clearances 3326−1/A1.........................................................................
Crosshead Pin − Removal and Installation 3326−2/A2..............................................
Piston
Removal and Installation 3403−1/A1..............................................................
Changing the Compression Shims 3403−2/A1.....................................................
Disassemble and Assemble 3403−3/A1...........................................................
Top Surface Check 3403−4/A1...................................................................
Piston Rings and Ring Grooves: Rate of Wear 3425−1/A1.............................................
Piston Cooling and Crosshead Lubrication: Inner Pipe − Removal and Installation 3603−1/A1...........
Driving Wheels and Shut-off Valve for Starting Air Group 4
Driving Wheels
Running and Backlash Clearances and Tooth Condition 4103−1/A1..................................
Starting Air Shut-off Valve: Clean and Function Check 4325−1/A1.....................................
Supply Unit, Injection and Exhaust Valve Control Group 5
Supply Unit
Servo Oil Pump and Servo Oil Pump Drive − Removal and Installation 5552−1/A1.....................
Camshaft and Bearing Shells − Removal and Installation 5552−2/A1.................................
Gear Wheel on Camshaft − Removal and Installation 5552−3/A1....................................
Supply Unit Removal and Installation 5552−4/A1...................................................
Lubrication of Supply Unit During Maintenance 5552−5/A1..........................................
Pilot Fuel Supply Unit: Lubrication 5555−1/A1.......................................................
Pilot Fuel Pump: Removal and Installation 5555−2/A1...............................................
Fuel Pump: Removal, Disassemble, Assemble, Installation 5556−1/A1................................
Fuel Pressure Control Valve: Removal, Check, Installation 5562−1/A1.................................
Fuel Pressure Control Valve: Manual Release Valve − Clean 5562−1/A2................................
Fuel Overpressure Safety Valve: Checks and Setting 5562−2/A1......................................
Flow Limiting Valve: Replacement 5562−3/A1........................................................
Fuel Pump Actuator: Connection to Fuel Pump 5583−1/A1...........................................
Exhaust Valve Control Unit: Removal, Disassemble, Assemble and Installation, 5612−1/A1.............
Winterthur Gas & Diesel Ltd. RT−flex50DF / MM / 2020
To Next Page