MaintenanceTOC
Table of Contents
RT-flex50DF
2016
4/ 4 Winterthur Gas & Diesel Ltd.
Regulating Linkage
Adjustment: Heinzmann StG 10-01 Actuator 5801−1/A1.............................................
Scavenge Air Receiver and Auxiliary Blower Group 6
Scavenge Air Receiver: Clean and do Checks 6420−1/A1.............................................
Scavenge Air Receiver (TC at Exhaust Side): Clean and do Checks 6420−2/A1.........................
Auxiliary Blower: Maintenance 6545−1/A1...........................................................
Auxiliary Blower (TC at Exhaust Side): Maintenance 6545−2/A1.......................................
Scavenge Air Cooler: Removal and Installation 6606−1/A1............................................
Scavenge Air Cooler: Cleaning Instructions 6606−1/A2...............................................
Scavenge Air Cooler (TC at Exhaust Side): Removal and Installation 6606−2/A1........................
Water Separator: Removal and Installation 6708−1/A1................................................
Water Separator Removal and Installation (TC at Exhaust Side) 6708−2/A1............................
Cylinder Lubrication Group 7
Cylinder Lubricating System 7218−1/A1............................................................
Piping Group 8
Exhaust Waste Gate (Low-load Tuning) 8135−1/A1.............................................
HP Servo Oil Pipe: Removal, Grind, Installation 8447−1/A1.......................................
Hydraulic Pipe for Exhaust Valve Drive: Removal, Grind, Installation 8460−1/A1........................
HP Injection Pipe:
Removal, Grind, Installation 8733−1/A1.........................................
HP Fuel Pipe: Removal, Grind, Installation (TC at Aft End) 8752−1/A1.................................
HP Pipe Pilot Fuel: Removal and Installation 8790−1/A1..............................................
Crank Angle Sensor Unit, Tools Group 9
Crank Angle Sensor Unit: Proximity Sensor − Replace 9223−1/A1..................................
Cylinder Pressure Sensor: Removal and Installation 9258−1/A1.......................................
Tools: Description 9403−1/A1.......................................................................
Hydraulic Jacks and Pumps: Configuration 9403−2/A1...............................................
Hydraulic Pre-tensioning Jacks
Storage, Servicing and Maintenance 9403−3/A1...................................................
General Application Instructions 9403−4/A1.......................................................
Tool List 9403−5/A1................................................................................
Standard Tools Pages 1 to 43...................................................................
Recommended Special Tools Pages 44 to 45......................................................
Winterthur Gas & Diesel Ltd.RT−flex50DF / MM / 2020
To Next Page